Monday, February 20, 2012

ROV camera enclosure update

Added an acrylic ring to reinforce the back flange, and got a bunch of big O-rings from mcmaster-carr. Seems to be coming along nicely...

Monday, February 13, 2012

ROV step 1: the wrong tool for the job?

A while ago my cousin, dad, and I decided we wanted to look around underwater at some favorite fishing spots. Clearly the most fun way to do this is to build a small remotely operated underwater vehicle (ROV). After kicking ideas around for a while, we decided that the first step would be to build a watertight enclosure for a camera and a bit of electronics, and stick it on the end of a long pole under water. This will allow us to test our enclosure for watertightness (at least to 15 or 20 feet of depth), and to work on the vision system.

To that end, I bought a few bits of PVC and all-thread from the hardware store, and ordered a piece of 1/2" clear acrylic.

I'm a big fan of using the right tool for the job, but sometimes you don't have it, and the job still needs to get done. In order to get things mounted up correctly, I wanted to mill out a few of the PVC pieces and the acrylic sheet. I don't have access to a milling machine, but if your tolerances are fairly loose, and your materials fairly soft, you can get by with a little creative use of a drill press and some end mills. Note: this is also bad for your drill press's bearings. They don't like side-loads.

Here I am milling the acrylic to shape, and cutting a groove for an o-ring to seal it (the acrylic sheet is an odd "circle with pieces missing" shape because I wanted to get 2 approximately 7" circles out of one 12" square piece of acrylic, in case I screw one up):

and here I'm drilling the holes for the all-thread:

Here is a toilet drain fitting I cut the middle out of to make a support ring for the other end of the all-thread:

and here are a couple shots of what the enclosure looks like at this point. The back is threaded, but I may end up gluing it shut if the threads are too leaky. The 3rd opening (on the top) is for the tether, I have to think a bit about how I want to proceed on that. (also, the whole thing is put together backwards in these pictures, when it's glued up the tether port will point towards the back instead of the front). You can also see the extra piece of acrylic and some foam with test-cuts in it in the background. I find insulation foam to be a good material to practice and test milling ideas on, because it cuts fast, doesn't put much wear on my end mills, and doesn't put heavy side-loads on the drill press.

and here's a closeup of the groove for the big o-ring:

The next steps are to put the camera in there, figure out how to seal up the tether entry, and do some depth testing!